Roof Edge Fall Protection Requirements

Understand the requirements of osha s fall protection standards at 29 cfr 1926 subpart m to protect workers exposed to falls six feet or more above a lower level.

Roof edge fall protection requirements.

The guard shall extend not less than 30. Conventional fall protection guardrail fall restraint or. Unprotected sides and edges. Implement safe work practices to reduce the possibility of falls.

Fall protection systems and other equipment they will be using on the job. Also osha compliance officers often do not cite a circumstance unless the worker is reasonably close to an unprotected edge. Conventional fall protection guardrail fall restraint or fall arrest system is required. I believe the misconception of a specific safe distance has surfaced since warning line rules require setbacks from the edge at 6 10 or 15 feet depending on the circumstances.

1910 28 b 8 i limits access within 6 feet 1 8 m of the edge of the pit to authorized employees trained in accordance with 1910 30. Less than 6 feet from the roof edge. Between 6 feet and 15 feet from the roof edge. Between 6 feet and 15 feet from the edge.

For work more than 15 feet from a roof edge the new rule states that the employer is not required to provide any fall protection provided the work is both infrequent and temporary. Employers are to ensure. Employers are to ensure that each employee is protected from falling by using fall. 1910 28 b 8 ii.

6 feet from the edge. Osha defines what fall protection is required based on how close employees are to the edge of the roof. For general industry working at a 4 foot height or a low sloped roof osha requires. In addition the code continues to specifically address fall protection near mechanical equipment which is where the edge accufit safety railing was being placed to protect requirements stating guards shall be provided where various components that require service are located within 10 feet of a roof edge or open side of a walking surface and such edge or open side is located more than 30 inches 762mm above the floor roof or grade below.

The use of a fall protection system is not required for a repair pit service pit or assembly pit that is less than 10 feet 3 m deep provided the employer.