You need to check the ball on the valve isn t full of water or hasn t slipped down the arm of the valve allowing the water level to get too high in the tank.
Roof water tank overflow.
Look inside the tank.
The pitch of gutter heading towards a downspout can also cause overflow if it s too steep.
Hook up a hose to the spigot at the bottom of the tank and drain enough water that the level of the tank falls below the valve in the tank.
In my last house i had two water supply systems.
If water continuous running out of hot water heater overflow and water heater overflow pipe gushing you have to change drain valve.
If you find water pouring or dripping from a pipe pointing out of the building or from eaves of roof then a cold water tank is overflowing.
The water feed into the tank isn t switching off.
If the valve is on the side of the tank this should be about 5 gallons.
If your cold water feed and expansion tank overflow pipe is leaking there are two possible causes.
So when the water heats up and expands the tank overflows.
Gravity feed rainwater from a header tank and pressure supply from a bore.
When rain water was low we switched over to the bore supply which caused water to dribble out of the roof top hot water cylinder overflow requiring an adjustment to the ajax valve every time we changed water systems.
Well if the temperature pressure relief valve is defective that means the tank is prone to some sort of damage.
So this release of its pressure causes your hot water tank overflow pipe dripping towards the floor where the hot water heater is placed.
A constant drip in your tpr valve is an indication we must know about.
This may be the smaller feed expansion cistern putting water into central heating circuit or it may be the storage cistern for cold water supplying the cold water bathroom taps and hot water cylinder.
Same goes for lack of pitch which causes the water to gather in one spot rather than flowing toward an exit.
A failure in the tpr valve could lead to a situation where the tank could even blast.
Turn on a hot water faucet somewhere in the house to a dribble to prevent a vacuum from forming inside your hot water tank.
If its the big tank that feeds your hot water cylinder it might be that the water level is too high in tank.
The water from the hot water heater overflow at the bottom of the tank.